Doing your nail prep properly is the key to making your gel extensions last as long as possible. 

PRODUCTS REQUIRED

• Cuticle pusher
• Cuticle clipper
• Nail file
• Nail buffer block

STEP 1

Trim or file your natural nails to ensure they fit nicely within the shape of your nail extensions. We recommend trimming them short for the best fit, however can leave them longer if you are growing out your natural nails. Use the buffer block to smooth out any rough edges.

STEP 2

Gently push back the cuticles using a cuticle pusher, and trim off any dead excess skin using a cuticle clipper. Be careful not to cut your skin or flesh on the sides of the nail plate. Ensure both the cuticle pusher and clipper are clean before use.

Optional: Soak your nails in warm water to soften the cuticles before pushing then back.

STEP 3

Using the buffer block, buff the surface of your natural nail. Use a clean cloth or paper towel to wipe off excess dust. 

Measure out the correct size for each nail by fitting the extension over your natural nail, ensuring that either edge of the extension meet the sides of your natural nail. There should be a small gap between the underside of the extension and the surface of your nail where the glue sits. Select the correct size of each nail and place them in order (i.e. L pinky to thumb, R thumb to pinky). 

Each box will include nail extension tips ranging from size 0-11, size 0 being the largest, and size 11 being the smallest.

Optional: If necessary, file around the edges of the extension for a closer fit around your cuticle.

We recommend applying the extensions one hand at a time.  

PRODUCTS REQUIRED

• Dehydrator
• Primer
• Gel Glue
• Pre-Sculpted Nail Extensions
• Flash-curing lamp
• Full-size LED/UV lamp

STEP 1

Apply a thin layer of the Dehydrator – pH bonder to the natural nail to remove any excess dirt or oil. Follow with a thin layer of Primer, avoiding the surrounding skin. This creates a tacky surface for the gel to adhere to. 

STEP 2

Apply a thin layer of Gel Glue to each nail, and cure under a full-size UV/LED lamp for 45 seconds.

STEP 3

Apply a thin layer to the underside of the extension from the cuticle edge, covering around the same area as the size of your natural nail. Add another bead size amount of glue to the cuticle edge.

STEP 4

Apply the extension to the natural nail on a 45 degree angle, lining it up about 1mm away from the cuticle on a 45 degree angle, then pressing down slowly until the glue spreads to cover the entire natural nail. Hold in place and cure under the flash-curing lamp for 10-15 seconds. Repeat on each finger. 

STEP 5

Cure the entire hand under the full-size UV/LED lamp for 60 seconds. Repeat on the other hand.

Optional: For the smoothest finish, take your nail file (180 grit side) and gently buff around the cuticle on surface of the extensions. This will ensure a smooth application of gel polish and help to prevent lifting.  

Apply the gel polish 1mm away from the cuticle to prevent it from adhering to your cuticle and skin. 

Cure each coat of gel polish for 60 seconds. 

Seal it off with our ultra-glossy Top Coat and nourish your cuticles with our luxurious cuticle oil!